Fitting into a standard x16 PCIe slot, this PCIe module allows advanced, repeatable testing of PCIe devices. Controlled from the TestMonkey GUI or any standard scripting language, the module is simple to integrate into your test plan. With full control over every active PCIe pin, you can perform:

Full hot-swap control of an attached PCIe card
Individual control of all lanes, side-band, power and present pins
Glitching of any signals
Active driving of CLKREQ, PERST and WAKE signals
Power margining and measurement via an additional Quarch power module
Optional external triggering
Optional inrush current limit.

This module comes with a 40cm interface cable and requires a separately-purchased controller.

QTL2128

This is the basic module.

QTL2087

This version includes external triggering IN/OUT via SMA cables to allow connection to an external analyser or similar.